 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
Fuselage Boxed. The
frame us upside down
for this step.
Notice motorcycle tie
downs strapped around
table to keep the top flat.
frame us upside down
for this step.
Notice motorcycle tie
downs strapped around
table to keep the top flat.
Longerons Bent in.
This step involved heating the
longerons with oxy-act and
bending them into a set
measurement. This was done
on both the front and back.
This step involved heating the
longerons with oxy-act and
bending them into a set
measurement. This was done
on both the front and back.
Installing the rear seat.
I jumped ahead on this step.
Now I can just sit in the plane
and think of what to do next.
I jumped ahead on this step.
Now I can just sit in the plane
and think of what to do next.
Rear seat with temp board in.
Bottom of front seat in.
| The seat pans were first made in a jig for accuracy, then welded in the fuselage. |