As received from Great Plains.
Tires: Kenda Corsa 4.10/3.50-5
Tubes : 410/350-5
Hydraulic brake kit.
Tires: Kenda Corsa 4.10/3.50-5
Tubes : 410/350-5
Hydraulic brake kit.
Disc spacers are bolted right to
the rims. The threads are too
long. I found new Grade 5 bolts
that extend 1 thread past the
nut.
The supplied bolts would catch
the brake caliper.
the rims. The threads are too
long. I found new Grade 5 bolts
that extend 1 thread past the
nut.
The supplied bolts would catch
the brake caliper.
Brake disc installed.
Caliper holders need to be
sanded out so the caliper can
slide. I used a dremel tool to
clean it up.
sanded out so the caliper can
slide. I used a dremel tool to
clean it up.
All the parts ready to install.
I have the landing gear upside
down on a bench for ease of
install.
I have the landing gear upside
down on a bench for ease of
install.
Notice the brake caliper holder
to the outside. The axle is
captive. 11mm aluminum
spacers will cover the gap on
the AN4-22A bolts.
to the outside. The axle is
captive. 11mm aluminum
spacers will cover the gap on
the AN4-22A bolts.
7/8" x 0.058 4130 spacers.
Turned out to be 1.80" in
length. (This can be varied)
Washers are missing from
this picture, but will be
installed later .
Will be powdercoated later to
match the axle. The brake
holder might also be coated.
Turned out to be 1.80" in
length. (This can be varied)
Washers are missing from
this picture, but will be
installed later .
Will be powdercoated later to
match the axle. The brake
holder might also be coated.
Labeled view of the axle
mount and hardware.
mount and hardware.
Labeled view of the axle and
brake mount.
brake mount.
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |